Need to expand a standard MechaBlok board using the one of standard on board interfaces? Then the MB6060 prototype board is your ticket to get a custom expansion design up and running Fast!!

Standard DIP type chips and discrete parts mount easily on this 2.8 X 2.8 inch (70mmx70mm) MechaBlox system compatible prototyping board.

The MB6060 is form compatible with the standard MechaBlox format, and supports all the standard interface connectors. And of course, the standard MechaBlox interfaces support power and ground connections. All you need to do is to add the interface device and you are up and running.

Prefer to prototype with an onboard +5VDC power supply? Check out the MB6050 Powered Prototype Board.

Specifications
Board Size-	2.8 X 2.8 inches (70mm x 70mm)
PCB-	Double- sided 0.62" FR4 epoxy-glass, 1oz. Copper. All holes are plated-through, pads on both sides.
Prototyping-	306 Plated through holes are 0.038in.on 100mil spacing, compatible with both Standard DIP (300-500mil widths) and wire-wrap sockets.
Mounting-	MechaBlox standard spacing, 4 X 0.125 diameter. Compatible with all MechaBlox standard boards.
Busses-	Top plane ground, botton plane two separate power buses (VCC, VCC2) Provision for bulk bypass capacitors, and up to 20 high frequency bypass Capacitors and/or power and ground tie points uniformally throughout the board.
Connectors-	All MechaBlox standard conenctors are supported,
Warranty	90 Day Limited Warranty
In stock?-	Coming soon!
McGourty Associates does not assume any responsibility for use of any circuitry described, no circuit patent licenses are implied. McGourty Associates reserves the right at any time without notice to change product specifications as may be required to permit improvements in the perfomance, reliability, or manufacturability. McGOURTY ASSOCIATES’ PRODUCTS ARE NOT AUTHORIZED FOR USE AS CRITICAL COMPONENTS IN LIFE SUPPORT DEVICES OR SYSTEMS.